Jinan Keya Electron Science And Technology Co., Ltd.
Main products:DC Controller,DC Servo Controller,DC Motor,DC Servo Motor,Brushless DC Motor
Products
Contact Us
  • Contact Person : Ms. Gu Annya
  • Company Name : Jinan Keya Electron Science And Technology Co., Ltd.
  • Tel : 86-0531-88601737
  • Fax : 86-0531-85898028
  • Address : Shandong,Jinan,No.78 Luohe West Street,Beiyuan Avenue,Tianqiao District,Jinan,China
  • Country/Region : China
  • Zip : 250031

Assembly with Reversing Contactor/DC Motor Speed Controller Kit

Assembly with Reversing Contactor/DC Motor Speed Controller Kit
Product Detailed
Assembly with Reversing Contactor/DC Motor Speed Controller Kit in:48VDC out:0-48VDC current:400A potentiometer control

Power Assembly with Reversing Contactor /DC Motor Speed Controller Kit

Please Carefully read this manual before using this product.

The controller assembly is composed of chopper, main contactor, reversing contactor, main circuit fuse, pilot circuit fuse and aluminum heating sink.

1.1 The controller assembly shall be installed in ventilated and dry place, near storage battery and motor, and away from rainwater.

1.2 The wires of pilot circuit and main circuit shall be properly connected according to the wiring diagram. First connect pilot circuit, 

and then connect main circuit with controller after inspecting the wiring to ensure its correctness.

 The sectional area of main circuit wire depends on the motor power and it is usually not less than 25mm2.

 The sectional area of control circuit wire is not less than 1 mm2.

1.3 Use multimeter to measure the direct current voltage on the either end of the storage battery to ensure 

its conformity with the required operating voltage for controller assembly.

1.4 Close key switch, and contactor pull-in sound shall be heard.

1.5 If the indicator light (green light) in the front of chopper is ON, it indicates normal conditions for the next step of debugging.

1.6 Lift up the vehicle to let the driving wheels off the ground.

1.7 Use remote control panel to individually control the forward or backward speed of the controller assembly.

2. Usage

2.1 Put down the lifted vehicle and let the driving wheels on the ground. Drive the vehicle according to the methods described in 1.7 and 1.8.

2.2 With the function of under-voltage protection, the controller assembly will 

stop working when its input voltage is lower than the 80% of its operating voltage.

2.3 With the function of over-voltage protection, the controller assembly will

 stop working when its input voltage is higher than the 120% of its operating voltage.

2.4 With the function of over-temperature protection, the controller assembly will

 stop outputting when the chopper temperature is higher than 75 and 

the controller assembly will automatically restore its current output 

after the chopper temperature declines. 

2.6 If the vehicle needs reversing during the running process, it shall be stopped before reversing.

  

4. Main Technical Parameters for Controller Assembly

Applicable voltage range 

Chopper operating frequency 

Electric lock input voltage

Electric lock input current

Over-voltage protection

Contactor driver operating voltage 

Contactor driver current 

Applicable ambient temperature for controller assembly

Maximum allowable temperature for chopper

Voltage range for acceleration signal input

Voltage range for potentiometer signal input

±20% of operating voltage

15KHZ

same as system voltage

60mA (typical value), pre-charge about 350mA in 3 seconds after starting

120% of operating voltage

same as controller operating voltage

2A(over-current protection 3A)

-25~50

75

1~5V

0~5V

Assembly with Reversing Contactor/DC Motor Speed Controller Kit



Copyright Notice @ 2008-2022 ECVERY Limited and/or its subsidiaries and licensors. All rights reserved.